FormIt 360 – Offset Tool

Recently I did a hour and half webinar on FormIt. It covered a lot of different topics and quite a few tips and tricks. I will post that soon once it gets cleaned up some more. In the mean time I thought I would take bits and pieces of it and make it into bite size chunks.

The first one I want to post is about the Offset tool. You can use this tool for a lot of modeling techniques but I wanted to show how to turn a mass into something that looks like walls, hence hollow it out. I also wanted to show how to use it for punched openings.

Hope you like…

This entry was posted in Autodesk Revit/BIM, Early Design. Bookmark the permalink.

Leave a Reply